How to Apply INDUSTRO WELD

Instructions:

MIXING:INDUSTRO WELD consists of two parts. Squeeze equal parts from each tube onto any clean disposable surface. Mix together thoroughly. A wooden dowel or paddle is a good mixing tool.

PREPARING SURFACE:Surface for application must be clean, dry, and free of dirt, grease, oil, etc. Remove any paint, primer, rust, etc. before applying INDUSTRO WELD. For the best weld, roughen surfaces to be welded with fine or course sandpaper.

APPLICATION:Apply with putty knife, spoon, wooden paddle, or other suitable tool. Avoid contact with skin and eyes. May be applied in an even coat, weld bead, or extruded shape as needed.

DRYING:Allow 4-6 hours for drying before handling. Allow to dry overnight (approximately 15 hours) before putting object to use. INDUSTRO WELD works faster if used in a room with a temperature above 50° F. After INDUSTRO WELD has cured for six hours, a heat lamp or light bulb placed near the weld will speed drying time.

IMPORTANT: In hot weather or in a very warm room, let INDUSTRO WELD set up or dry for about 15 to 20 minutes after mixing. This lets it thicken and prevents running or sagging. In cold weather, a heat lamp or light bulb placed close by will hasten drying time.

Using J-B WELD products is easy.
Squeeze out equal portions. Mix thoroughly.
Clean surfaces, apply INDUSTRO WELD, and let it cure.
That's all there is to it!